How it works

Technical | Frequently Asked Questions | Tech Support

NANO does not operate as a traditional “push” system. Instead, it uses Mass Flow Regulation to maintain bottle pressure compensation throughout the run.

In conventional nitrous systems, as the bottle empties, the vapor space at the top increases. This larger vapor volume takes longer to refill and re-pressurize. At the same time, as liquid nitrous turns into vapor, the bottle temperature drops — slowing pressure recovery even further. The result is inconsistent flow and reduced performance, especially at higher horsepower levels or with larger bottles.

Traditional Nitrous Facts

A typical 10 lb nitrous bottle only delivers about 6 lbs of usable nitrous.
Performance depends heavily on both vapor volume and bottle temperature.

The Problem

Vapor pressure recovery time increases as bottle vapor volume expands and temperature drops.
As nitrous is consumed, vapor volume grows, liquid mass decreases, and bottle pressure becomes unstable.

The NANO Solution

Maintains a consistent mass flow rate of liquid nitrous oxide from full to empty.
Stabilizes vapor column volume and bottle vapor pressure.
Ensures steady, predictable power output from launch to finish line.
Works with setups ranging from 50 HP to 550 HP+.

In short: NANO eliminates the common power drop-off seen in traditional systems by keeping pressure, density, and flow consistent all the way down the track — giving you maximum and repeatable performance run after run.

What Is a PUSH System — and How Is NANO Technology Different?

At first glance, some people might mistake NANO Technology for what was once known as a PUSH system, but the two are completely different.

A PUSH system was an older method that attempted to increase nitrous pressure inside the bottle using an external “capping gas” such as nitrogen. This gas would pressurize the liquid nitrous oxide to artificially raise the bottle’s internal pressure — essentially acting as a vapor pressure override system. While this approach could momentarily boost pressure, it often caused instability, inconsistent flow, and safety concerns. Because of these drawbacks, PUSH systems were never widely accepted by the racing community.

NANO Technology, on the other hand, takes an entirely different approach. Instead of forcing extra pressure into the bottle, NANO maintains the nitrous oxide’s natural mass flow rate — the same steady flow that occurs when a bottle is full and at ideal operating temperature. In every run, temperature and pressure naturally change inside a nitrous bottle, affecting flow. The NANO system continuously compensates for these pressure and temperature variations, keeping the bottle at its natural vapor pressure regardless of how full or empty it is.

This automatic balancing process is known as Natural Pressure Vapor Compensation — the key to delivering consistent, repeatable nitrous performance from start to finish, without the risks or drawbacks of old “push” systems.

Safety:
– Check Valve: Anti-reversion check valve.
– DOT Certification – Legal U.S.
– Canadian Certification – 3HWM – Legal CAN.
– Breathable Inert Gas
– High Low Pressure Burst Disks.

HPN Nitrogen vs. Air (HPA)
Why Did Push System Not Work Well
1. Used Nitrogen instead of HPA
2. Regulator Technology did not exist that would regulate “Mass Flow Rate”
3. Storage Vessel’s had limited storage volume and pressure.

Interesting Facts.

Static bottle Pressure 950 +/- 25 psi
Dynamic Pressure 900 +/- 25 psi

PERFORMANCE ADVANTAGES LIT SHEET

Increases in Performance.
o Perfect flow of nitrous every time till the nitrous bottle is empty.
o Delivers the same increase in HP all the way down the track.

Absolutely Consistent and Reliable.
o Performance does not change with bottle temperature.
o Performance does not change as nitrous bottle empties.
o Tune your car one time and get the same results every run.

Flexible and Adaptable:
o Add it to any existing nitrous oxide system
o Adapts automatically when you re-tune your vehicle
From 5 to 550 HP
o Works with any nitrous controller.
o Light Weight.
o Aluminum Bottle.
o Pure Technology.

Easy to Install:
o Add NANO to your existing kit in 30 minutes or less.
o No electrical connections. Completely mechanical.
o Easy Mount Brackets
o Just turn your NANO bottle on and off – one turn.

Easy to Fill NANO bottle with your choice of HPA or HPN.
o HPA and HPN available at most paint ball stores.
o SCUBA Shops carry HPA
o Local Fire Stations usually have HPA (breathable air) available.
o We offer fill station solutions.
Cost Effective.
o Simply add NANO Technology to your existing nitrous system.
o Eliminates the need for bottle heaters and similar Nitrous enhancements.
o Add-on kit comes complete; lines, bottle, and brackets.
o Doubles the amount of race time from your nitrous bottle.

Safe
o DOT Transport Certified to E-9894
o Canada Transport Certified to 3HWM
o Comes with High & Low Pressure Burst Disks.
o Includes Anti-N20 Reversion check valve

Manageable.
o View the amount of N20 remaining in your bottle.
o Consistency of system allows you to do a more precise tune.

Patented Technology.
o Patented Mass Flow Regulation
o Patented Self Contained Regulation
o Patent Pending – Check Valve.

GET NANO AND YOU GET
 Full power All the Time.
 Use of All the Nitrous in the bottle
 No More Disappointment
 Full Power Full Track.

BPC = Bottle Pressure Compensation
BPO = Bottle Pressure Override.
VPC = Vapor Pressure Compensation

NANO DOES WHAT THE OLD PUCH SYSTEM COULD NOT DO.
NANO ACHIEVES WHAT THE PUSH SYSTEM COULD NOT.
NANO PERFECTS NITROUS POWER

ALL YOUR POWER ALL THE TIME!!

NANO’s Mass Flow Regulation works for all users including from system for the
street to full competition.

–GET NANO OR GET OWNED….